sE Electronics Voodoo VR2 Ribbon Microphone
The Se Electronics Voodoo VR2 Ribbon microphone is the mark of a new era for Ribbon mic technology – until now the only Ribbon mic in the world to perform across 20Hz-20KHz was our own Rupert Neve collaboration, the RNR1, critically acclaimed as the best Ribbon mic in the world. This was achieved using state of the art transformers and a Rupert Neve designed circuit board to reveal HF usually absent.
The Voodoo VR2 mic achieves full frequency response using a new mechanical device, designed by Siwei Zou, the company CEO. This extraordinary technical achievement allows the traditional Ribbon capsule to develop and capture frequencies from 20Hz to 20KHz like no other Ribbon on the planet.
The sound is revolutionary; where the RNR1 is simply a stunning mic in its own class entirely, the Voodoo range brings traditional ribbon sound to the project and commercial studio, but extends it to perform as well as most condensers do. The result is superbly detailed and wonderfully open and natural sounding recordings of acoustic instruments and guitar cabs.
The VR2 is an ‘active’ version of the VR1, which is the more traditional ‘passive’ Ribbon design.
These mics’ unique ability to perform, coupled with searingly good looks, is sure to make the VR1 and VR2 classics of their time.
- Operating Principle: Pressure Gradient
- Diaphragm 2µ: aluminium ribbon
- Frequency Response: 20Hz-18KHz
- Sensitivity: 10mV/Pa -40 ± 1.5dB
- Polar Pattern: Figure 8
- Impedance: = 200 Ohms
- Equivalent Noise Level: 20dB(A weighted)
- Max SPL for 0.5% THD@1000Hz: 135dB
- Power Requirement: Phantom power 48V±4V
- Connector: 3-pin